Thread: realtek 8192se - scan properly but doesnt connect
hi everybody.
i've been searching around trying solve issue havent been able working.
problem wireless card on laptop detects wireless networks can't connect them. think it's os problem cause have dual boot windows 7 x64 , hadnt trouble since bought it.
it
when i'm trying connect network asks me password 'wireless network authentication required'. i've checked tons of times password writting right one, keeps me asking if put wrong.
disabled kind of wireless security on router (first had wpa2-psk) , tried connect again. had remove network manager's entry of network stop asking me password.
once tried connect without asking password (because @ point wireless open) kept trying connect several minutes until disconnected.
suspected there problem dhcp. couple of months ago, tried connect command-line. went right until had ip address. @ point dhclient hanged requesting address.
tried connect network using statc ip address. network addres 192.168.2.0 put address didnt collided of hosts connected it. again, kept connecting while wireless open or asking password when wasnt.
seems odd me, cause connect neighbours' wireless network , havent trouble connecting university's.
here follows information of system:
i'm sorry if have opened new thread existing topic, didnt found posted last months.code:1 ) machine brand , model (pc/laptop): toshiba satellite a500-18q 2 ) wireless brand, model , wireless chipset: 14:00.0 network controller: realtek semiconductor co., ltd. rtl8191sevb wireless lan controller (rev 10) 3 ) check interface: ifconfig wlan0 link encap:ethernet direcciónhw xx:xx:xx:xx:xx:xx activo difusiÓn multicast mtu:1500 métrica:1 paquetes rx:0 errores:0 perdidos:0 overruns:0 frame:0 paquetes tx:0 errores:0 perdidos:0 overruns:0 carrier:0 colisiones:0 long.colatx:1000 bytes rx:0 (0.0 b) tx bytes:0 (0.0 b) iwconfig wlan0 ieee 802.11bgn essid:"bcast" mode:managed frequency:2.412 ghz access point: not-associated tx-power=20 dbm retry long limit:7 rts thr=2347 b fragment thr:off power management:off 4 ) check modules: rtl8192se 93999 0 rtlwifi 118703 1 rtl8192se mac80211 462092 2 rtl8192se,rtlwifi 5 ) kernel boot messages [ 0.000000] percpu: embedded 27 pages/cpu @ffff88013fc00000 s79616 r8192 d22784 u1048576 [ 0.000000] pcpu-alloc: s79616 r8192 d22784 u1048576 alloc=1*2097152 [ 22.252372] rtl8192se 0000:14:00.0: pci int -> gsi 19 (level, low) -> irq 19 [ 22.252381] rtl8192se 0000:14:00.0: setting latency timer 64 6 ) network configuration *-network description: wireless interface product: rtl8191sevb wireless lan controller vendor: realtek semiconductor co., ltd. physical id: 0 bus info: pci@0000:14:00.0 logical name: wlan0 version: 10 serial: 70:1a:04:64:1c:c0 width: 32 bits clock: 33mhz capabilities: pm msi pciexpress bus_master cap_list ethernet physical wireless configuration: broadcast=yes driver=rtl8192se driverversion=3.0.0-14-generic firmware=n/a latency=0 link=no multicast=yes wireless=ieee 802.11bgn resources: irq:19 ioport:5000(size=256) memory:f6000000-f6003fff 7 ) scan networks: cell 11 - address: xx:xx:xx:xx:xx:xx channel:1 frequency:2.412 ghz (channel 1) quality=70/70 signal level=-34 dbm encryption key:on essid:"bcast" bit rates:6 mb/s; 9 mb/s; 12 mb/s; 18 mb/s; 24 mb/s 36 mb/s; 48 mb/s; 54 mb/s mode:master extra:tsf=0000000244a2304b extra: last beacon: 9220ms ago ie: unknown: 00054243617374 ie: unknown: 01088c9298a4b048606c ie: unknown: 030101 ie: unknown: 050401030000 ie: unknown: 2a0104 ie: ieee 802.11i/wpa2 version 1 group cipher : ccmp pairwise ciphers (1) : ccmp authentication suites (1) : psk ie: unknown: dd0700e04c01020300 8 ) ubuntu version: ubuntu 11.10 9 ) kernel/architecture (including 32 vs. 64 bit): 3.0.0-14-generic x86_64 10 ) restarting network: * reconfiguring network interfaces... [ ok ]
greetings
Forum The Ubuntu Forum Community Ubuntu Official Flavours Support Networking & Wireless [ubuntu] realtek 8192se - scan properly but doesnt connect
Ubuntu
Comments
Post a Comment